The Artex DGL-1 programming dongle allows the operator to easily program aircraft 24-bit (Standard Message Protocol) address into a compatible ELT. Universal programmer: Dongle and Repair Box -, universal programmer, Chip programmer, IC Programmer, ISP programmer, production programmer, IC sockets, chip adapters. Stata Mp Serial Mac Booster. Ready for operation. Disconnect the Ositech Bluetooth dongle from the Programming Device, and connect it to your host LP12 / 15 system.
I have been using a software program which is protected with a usb hardware lock key. I need to eliminate this hardware key and run the program. Also this programwill expires at a certain period of time. How do i eliminate this?
Pls note i have no history of cracking softwares. How to upload the files and send the link? I have 1 dongle type rockey, flowing locks who said: - USB DONGLE Search1.21 Start here ------- ------ Rockey; [unknown]; USB VID_096E & PID_0201 & REV_010? Rockey; [unknown]; HID VID_096E & PID_0201 & REV_010? ---------- ---------- End - USB keys toll identification v.111 Found Faitian USB key (unknown type) HID USB key Found Faitian (unknown type) Thanks mail.
Assuing that you have the FCHid program up and running, all you need to do is enter the frequency in kHz and press the Set Frequency button. So, for 100MHz you’d enter 100000 and press the Set Frequency button. That’s all there is to it.
The Defaults button is used to set some gain and filter settings if you are on the early 18b firmware. It does not set the frequency. Later firmware versions (including 18c) have the appropriate default settings set so there should be no need to use the Defaults button unless you want to go back to some sensible values after soe tinkering.